Table of Contents
Advertisement
Display: 3.8.5
Display: 3.8.5
[...........]
[...........]
Display: 3.8.6
Display: 3.8.6
[Time controlled]
[Time controlled]
Display: 3.8.6.1
Display: 3.8.6.1
EN
"min" (heat source's minimum value) flashes after
confirmation of the maximum value.
: set the minimum value.
SET: press button to confirm.
The settings are saved.
Defining limits for the heat target
: press button.
The display for setting the limit of the heat target appears.
SET: press button.
"max" flashes in the display (heat target's maximum value).
: set the maximum value.
SET: press button to confirm.
Activating time control
: press button.
The "Time controlled" display appears.
SET: press button.
Time control is activated.
: press button.
The display for setting the duration appears.
SET: press button.
The time value flashes in the display.
: set the time value.
SET: confirm the value and go to the next value.
The settings are saved.
NOTE
The switch-on time must always be before the switch-off time. There-
fore, when the switch-on value is being adjusted, the switch-off value
will also be changed to a later time if necessary. Adjusting the switch-off
value to a time before the switch-on value is blocked.
730.137 | 08.37
73
Advertisement
Table of Contents
