Snom D710 Manual page 10

With the headset
Press .
With the speaker / microphone
Press the speaker key
1.4. Hold
Press the hold key
Calls on hold are indicated in three ways:
by the display text
the slowly flashing green/red line LED (i.e., when the first four freely programmable function
keys are not programmed; on snom D735 and D785 the LED flashes red only
and with the continuous red call LED.
Calls on hold can now be transferred or other calls can be made or put on hold.
Press the hold key
to the call on hold. If the party on hold hangs up while on hold, the connection is terminated.
Please click on the soft key "Hold" under the display to use "Hold" with snom D710/D712.
1.5. Call waiting and toggling calls
If a call comes in while you are on a call, the display shows an icon with a ringing receiver and a
double call waiting tone (double beep) can be heard.
Options
You can answer the incoming call, which automatically places the active call on hold.
Ignore the incoming call with
You can also transfer the incoming call without announcing it.
In case of an incoming call during an active call, you can reject the call by holding
the X key for several seconds. To end the active call first, briefly press the X key.
You can then accept the waiting call.
On the snom D710/D712, please press the "Trans" soft key to forward the active
call. Then you can accept the incoming call.
For Snom D735/D785: In case of an incoming call during an active call, click on the
icon with the ringing handset and then briefly on X.
to activate the speaker / microphone and answer the call.
/ (on snom D735 and D785) to place the active call on hold.
/ (on snom D735 and D785) or the respective line key, to return
. The caller hears a busy tone.
10