Table of Contents
Advertisement
Additional interfaces
Using an external antenna
You can connect an external antenna to the EXPLORER 500.
Important
The connector for the external antenna is located at the
back of the EXPLORER 500 and is marked ANT.
For information on cable and connector type, refer to the
specifications in External antenna on page 159.
Using the EXPLORER™ Bluetooth Handset charger
Before connecting to the EXPLORER™ Bluetooth Handset charger interface
If you are using an EXPLORER Bluetooth Handset, you can recharge the handset using the DC
charger interface of the EXPLORER 500.
Use the charger cable supplied with the EXPLORER Bluetooth Handset.
For specifications on the charger interface, see EXPLORER™ Bluetooth Handset charger interface
on page 160.
Connecting to the EXPLORER™ Bluetooth Handset charger interface
Do as follows:
1.
Connect the EXPLORER 500 to power, either using the AC/DC adapter connected to a 100-
240 V AC electrical outlet, or the Car charger cable connected to the cigarette lighter
socket/12 V DC in a car.
Note
2. Connect the Bluetooth charger cable to the charging
connector on the EXPLORER 500.
The charging connector is located at the back of the
EXPLORER 500, and is marked DC OUT. Make sure the
connector is oriented correctly in relation to the coding
of the plastic insert.
3. Connect the other end of the cable to your EXPLORER Bluetooth Handset.
If the EXPLORER 500 is connected to power, the battery of the Bluetooth Handset is now
recharged.
TT 98-122274-O
Only use the specified antenna from Thrane & Thrane. The antenna is listed in
Options and accessories on page 137.
The Bluetooth handset charger cannot recharge the Bluetooth handset from the
EXPLORER 500 battery. The EXPLORER 500 must be connected to external power.
Additional interfaces
Chapter 4: Using the interfaces
73
Advertisement
Table of Contents
Troubleshooting
