Inmarsat EXPLORER 500 User Manual page 71

Holding a call
Note
The phone must have an R key to be able to use these functions.
The EXPLORER™ Bluetooth Handset uses a softkey in stead of the R key.
During a call, you may place the initial call on hold while another call is made.
If you want to:
Place a call on hold.
Place the existing call on hold and establish a
new call.
Shuttle between the two calls.
Clear the held call, if no waiting call exists.
Clear an active call and return to the held call.
Transferring a call
Note
The phone must have an R key to be able to use these functions.
The EXPLORER™ Bluetooth Handset uses a softkey in stead of the R key.
When you receive a call, you can transfer this call to another phone or headset connected to the
EXPLORER 500.
To transfer the incoming call to another phone or headset, do as follows:
1. Press R 4 * <local number> #.
The phone or headset with the local number you dialed starts to ring.
If your phone and the recipient's phone or headset are both Bluetooth devices, your phone is
now disconnected. When the call is answered, a connection is established between the initial
caller and the new recipient.
2. If only one or none of the devices are Bluetooth devices, you have two options.
• Hang up. The phone or headset you transferred the call to continues to ring. When the call
is answered, a connection is established between the initial caller and the new recipient.
• Do not hang up. When the new recipient answers, you can have a conversation before
hanging up. When you hang up, the call is handed over to the initial caller.
TT 98-122274-O
Do as follows:
Press R 2 #.
Press R and dial the second phone number
followed by #.
Press R 2 #
(irrespective of whether the second call was
acquired using Call Hold or acceptance of Call
Waiting.)
Press R 0 #.
Press R 1 #.
Note that this is only possible if no waiting
call exists.
Using a phone or fax machine
Chapter 4: Using the interfaces
61