Inmarsat EXPLORER 500 User Manual page 54

Viewing terminal properties
You can view properties of the EXPLORER 500 such as IP address, hardware numbers, software
version and IMEI number. When contacting Support, please include these numbers.
To view the properties, do as follows:
Select PROPERTIES > TERMINAL.
1.
2. Select one of the following options:
• IP ADDRESS to see the IP address of the EXPLORER 500. This IP address is used to
access the web interface of the EXPLORER 500. The web interface is a built-in web server
used to configure and set up the EXPLORER 500. For further information on the web
interface, see Using the web interface on page 75.
• HARDWARE to see the serial number, PCB numbers and MAC address of your
EXPLORER 500.
• SOFTWARE to see the software version of the EXPLORER 500.
• IMEI to see the IMEI number (International Mobile Equipment Identity) of the
EXPLORER 500. This is the unique mobile equipment number that identifies your
EXPLORER 500. The IMEI number is also printed on the serial number label at the back of
the terminal.
Viewing mobile subscriber numbers
If available on the SIM card, the MOBILE NUMBERS menu lists the mobile subscriber numbers
to use when calling the EXPLORER 500.
Note
There are two voice numbers, one for 3.1 kHz Audio and one for Standard Voice. For
further information, see Selecting the call type on page 52.
To view the mobile subscriber numbers, select PROPERTIES > MOBILE NUMBERS.
If the mobile numbers are not available, the display reads
NO INFORMATION AVAILABLE.
Viewing the voice mail number
The EXPLORER 500 informs you of any incoming voice mail through the display and through the
web interface.
The voice mail number is the number you call to hear your incoming voice mail.
If available on the SIM card, the PROPERTIES menu shows the voice mail number.
To view the voice mail number, select
PROPERTIES > VOICE MAIL NUMBER.
If the voice mail number is not available, the display reads
NO INFORMATION AVAILABLE.
TT 98-122274-O
Chapter 3: Using the display and keypad
44