Parameters Saving; Diagnostic; Commands; Current Flow Rate - Pentair FLECK 3900 NXT Installer Manual

Installer Manual Fleck 3900 - NXT - Programming

6.5.21. Parameters saving

Note
When the last parameter is set and the button
database based on the new programming. Wait until programming is finished, this may take
a few seconds.
6.6.

Diagnostic

Note
Depending on current settings, some displays cannot be viewed.
Note
There is no time limit on the displays in the Diagnostic mode.

6.6.1. Commands

A Press D to enter the Diagnostic mode.
B Press to pass at the next step.
C Press D to exit the Diagnostic mode at any time.

6.6.2. Current flow rate

Note
The display is updated every second.

6.6.3. Peak flow rate

Note
The controller registers the highest flow rate since the last regeneration.
74 / 126
pressed, the controller updates the
PROGRAMMING UNIT
PLEASE WAIT...
CURRENT FLOW RAT
L/min
PEAK FLOW
Ref. MKT-IM-015 / B - 08.06.2018
0Lpm
RATE
0Lpm