Basic Function; Radio Operation - Hyundai TRC 282 DRU3 Instruction Manual

AC POWER
You can power your portable system by plugging the detachable AC power cord into the AC inlet atthe back of the unit and into
a wall AC power outlet. Check that the rated voltage of your appliance matches your local voltage. Make sure that the AC power
cord is fully inserted into the appliance.
BATTERY POWER
Insert 6 x "C" size batteries into the battery compartment. Be sure that the batteries are insertedcorrectly to avoid damage to the
appliance. Always remove the batteries when appliance will not beused for a long period of time, as this will cause leakage to
the batteries and subsequently damage to your set.
Notes:
- Use batteries of the same type. Never use different types of batteries together.
- To use the appliance with batteries, disconnect the AC power cord from it.
REMOTE CONTROL
1) POWER
2) FUNCTION
3) REPEAT
4) RAND
5) SKIP −
6) VOLUME −
7) PRE-DN
8) PRE-UP
9) STOP
10) VOLUME +
11) SKIP +
12) PLAY / PAUSE
BATTERY INSTALLATION
Insert a "Cell" size batteries into the battery compartment. Be sure that
the batteries are inserted correctly to avoid damage to the remote control.
Always remove the batteries when the remote control will not be used
for a long period of time, as this will cause leakage to the batteries and
subsequently damage to your set.
Notes:
- If the distance required between the remote control and the appliance
decreases, the batteries are exhausted. In this case replace the batteries
with new one.
- Power button on main unit must be "On" in order for Remote Control to operate.
SENSOR WINDOW OF THE RECEIVER
- Even if the remote control is operated within the effective range, its operation may be impossible if there are any obstacies
between the appliance and the remote control.
- If the remote control is operated near other appliances which generate infrared rays, or if other remote control devices using
infrared rays are used near the appliance, it may operate incorrectly.

BASIC FUNCTION

GENERAL OPERATION
- At standby mode, press the "ST / FUNC" button to switch on the unit.
- Press the "ST / FUNC" button once to switch other mode. (Only have Radio mode and CD / MP3 / USB / AUX-IN.)
- Press and hold the "ST / FUNC" button for 3 seconds to switch off the unit. (No matter in which mode.)

RADIO OPERATION

GENERAL OPERATION
1) Press the "ST / FUNC" button to select "FM" mode.
2) Adjust radio frequency to your desired station by using the "TUNING +" or "TUNING −" button.
FOR BETTER RECEPTION
FM – This appliance has a FM antenna located at the rear cabinet. This wire is completely unraveled and extended for better
reception.
FM / FM STEREO RECEPTION
1) Press "STOP" button to choose Mono or Stereo.
2) Stereo icon will be shown on display in Stereo mode.
PRESET STATION
1) Select the desired radio station
2) Press the "MODE" button, the display will show "P01".
3) Press the "MODE" button again to confirm into the program memory.
4) Repeat step1, 2 and 3 to enter other radio station into the program memory.
5) When all the desired station have been programmed, press the "Auto / Album" button to play the desired station in the order
you have programmed.
AUTO SEARCH
Press the "PLAY / PAUSE/SCAN" button to do auto search function.
Slide out cover and install single "Cell"
batterywith polarities as shown.
EN - 19
1
2
3
4
5
6
INSTALLING BATTERIES
+
EN
7
8
9
10
11
12