Equinox Systems Axis 50W Gobo Flower User Manual page 12

Software version:
To access the fixtures software version, press the "MENU" button and use the "UP" and "DOWN" buttons
on the rear of the unit to show
The unit will now display the fixtures software version.
To exit out of any of the above options, press the "MENU" button.
Gobo wheel position adjustment:
To access the offset menu for the gobo wheel home position adjustment setting, press the
"MENU" button once and hold the "ENTER" button for 3 seconds to display
display. Now press the "ENTER" button to display
"UP" and "DOWN" buttons to set the required zoom home position between
Press the "ENTER" button to confirm the setting.
CA 8 function:
The unit has a CA 8 remote control input on the rear. This may be used with the CA 8
hand controller (sold separately) to control the unit. Please see functions below.
Blackout - By pressing the Stand By button the fixture will blackout.
Mode - Use this button to put the fixture into auto, show or motor speed modes.
Auto mode (Show 0) - LED off
Motor speed (1-9) - LED on
Show modes (Shows 1-7) - LED flashing
Function - Once you have chosen the mode you require use this button to set the motor speed
or show mode.
Motor speed (1-9)
Show modes (Shows 1-7)
www.prolight.co.uk
VEr
on the LED display. Now press the "ENTER" button.
Gobo
Axis 50W Gobo Flower User Manual
Operating instructions
OSEt
. Press the "ENTER" button and use the
128
on the LED
127
~ .
12