Equinox Eyebar Safety WARNING FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOUR INITIAL START-UP! CAUTION! Keep this equipment away from rain, moisture and liquids. SAFETY INSTRUCTIONS Every person involved with the installation, operation & maintenance of this...
Equinox Eyebar Safety IMPORTANT: The manufacturer will not accept liability for any resulting damages caused by the non-observance of this manual or any unauthorised modification to the equipment. • Never let the power-cable come into contact with other cables. Handle the power-cable and all mains voltage connections with particular caution! •...
Page 4
“SLA2” option: This is the inversion slave mode, where the slave unit will react in the opposite direction from the master unit. Note: After making any changes to the above settings, please allow the Eyebar 5 seconds to register the change.
Page 5
Equinox Eyebar Overview Overview DMX Function Chart Channel Value Function 0-255 Green and White LEDs (0-100%) 0-255 Red and Amber LEDs (0-100%) Blue LEDs (0-100%) 0-255 Master Dimmer (0-100%) 0-255 Strobe (slow-fast) 0-255 Programme Selector 0-255...
Page 6
DATA Cable (DMX cable) requirements (for DMX operation): • The Equinox Eyebar can be controlled via DMX-512 protocol. The DMX address is set on the back of the unit. Your unit and your DMX controller require a standard 3-pin XLR connector for data input/output (figure 1).
Page 7
Equinox Eyebar DMX Set up Notice: • Be sure to follow figures 2 & 3 when making your own cables. Do not connect the cable’s shield conductor to the ground lug or allow the shield conductor to come in contact with the XLR’s outer casing.