Vision Engraving & Routing Systems 1624R Installation Manual page 20

Hide thumbs Also See for 1624R:
Table of Contents

Advertisement

20
Vision 1624R, 2525 and 2550 Series 5 Installation Guide
Engraving Head Removal Procedure
1. Remove the Motor Plug from the back of the Carriage and place it over the Cable/Hose Hanger.
2. Loosen the four mounting screws and remove. The Engraving Head will be held in place on the Rail
Plate by the two Dowel Pins on the back of the Mounting Plate.
3. Using two hands, pull the Engraving Head away from the Rail Plate.
To Install the Engraving Head, reverse this procedure.
© 2020 Vision Engraving & Routing Systems

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 1624R and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

25252550

Table of Contents