E Calibration - Fetco CBS-1241 Users Manual And Operator Instructions

E Calibration

POSITION Program Items
Ready Temp.
E1
Offset
E2 LLC Sensitivity
Slow flow rate
E3
from supply
LT Brew valve
E4
flow rate:
RT Brew valve
E5
flow rate:
LT Bypass valve
E6*
flow rate:
RT Bypass valve
E7*
flow rate:
*Active if bypass is installed and activated on equipment
Use this formula to compensate for minor discrepancies in actual volume versus programmed volume.
See "PROGRAM" E4 & E5 For valve settings and calibration. Factory set brew valve flow rates are in liter/min
ACTUAL VOLUME
X
PROGRAMMED VOLUME
Use the formula above to determine the correct setting
Go to fetco.com for the latest versions of all information
Brewer Sensors and Keypad
Factory set Default
-4°F
-2°C
NORMAL
("NORMAL" for most
water)
ON
0.50 gallon/minute
(1.85 liter/minute)
(64 ounces/minute)
0.50 gallon/minute
(1.85 liter/minute)
(64 ounces/minute)
0.37 gallon/minute
(1.60 liters/minute)
(47 ounces/minute)
0.37 gallon/minute
(1.60 liters/minute)
(47 ounces/minute)
CURRENT NEW
=
SETTING SETTING
Programming Range Increments
-2° to -9°F 1°F
-1° to -5° C 1°C
HIGH
NORMAL
(Biased for reverse
osmosis water or
HIGH
very pure water)
Toggle +/-
OFF/ON
YES or NO
0.42-0.58 Gallons 0.01G
1.55-2.20 Liters 0.05L
53-74 fl.ounces 1 oz.
0.42-0.58 Gallons 0.01G
1.55-2.20 Liters 0.05L
53-74 fl.ounces 1 oz.
0.30-0.43G 0.01G
1.10-1.65Liter 0.05L
38-56 fl.ounces 1 oz.
0.30-0.43G 0.01G
1.10-1.65Liter 0.05L
38-56 fl.ounces 1 oz.
Default Brew Valve Flow Rate—CBS-1240 Brewers
CBS-1240
Right and Left Brew Valve FR
Right and Left Bypass Valve FR
Set FR lower to increase volume,
Set FR higher to decrease volume
User Guide & Operator instructions
Page 10
Notes
Compensates output to
measured temperature
Liquid level control
sensitivity.
High,1300Ω is for reverse
osmosis water or very
pure water.
Trims fill system for low
supply or Flojet use
Adjusts flow rate
Adjusts flow rate
Adjusts flow rate
Adjusts flow rate
Gal/minute Range
0.50 0.42g to 0.58g
0.37 0.30g to 0.43g
P212e0August 2021