UTC Fire and Security interlogix TT3010 Installation & Operation Instructions page 7

Product Disassembly Instructions for WEEE
Per European Directive 2002/95/EC Waste Electrical
Required Tools:
One number 2 Phillips (crosstip) screwdriver.
One number 2 flat screwdriver.
For the enclosed box version:
1. Locate and remove box cover securement screws.
Usually, but not limited to at least 4 screws.
2. Lift off box top cover.
3. Locate and remove securement screws for printed circuit board.
4. If there are multiple boards to the assembly, continue removing
securement screws until none are left.
5. Lift off printed circuit board(s).
6. Disassembly of box version of product is complete.
For the rack version:
1. Locate and remove box cover securement screws
for printed circuit board. Usually, but not limited to at least 4 screws.
2. If there are multiple boards to the assembly, continue removing
securement screws until none are left.
3. Lift off printed circuit board(s).
4. Disassembly of box version of product is complete.
TT/TR3000 Environmental Specifications
MTBF:
Operating Temp:
Storage Temp:
Relative Humidity:
May be extended to condensation conditions by adding suffix '-C'
†
to model number for conformal coating.
and Electronic Equipment
>100,000 hours
-40˚C to +74˚C
-40˚C to +85˚C
0% to 95% (non-condensing)
†