Table of Contents
Advertisement
Add, Edit or Delete Transmitter Codes
When adding or editing transmitter codes, note the following:
• The label on the back of the transmitter displays the codes necessary to program the transmitter.
ID Number
Button Number
Codes for Buttons 1-3
Codes for Button 4
• Keep a record of each transmitter code you assign; in particular, write down the resident names
associated with each transmitter. This will help when adding, editing, or deleting transmitter codes
later.
• Once the ID number, sequence, facility and transmitter number are programmed use the chart in the
illustration.
• When adding transmitters buttons 1-3 are automatically entered and active. You do not have to repeat
a step for buttons 2 and 3.
Add a Basic Transmitter:
Add a Basic transmitter to the system's database. A basic transmitter will be active,
unlock all doors/gates assigned to the RF module with no time constraints (i.e., can be
used 24 hours a day, 7 days a week). For Full Function transmitters (i.e., transmitters
with additional options such as schedules, assignments per door), see next page.
Press
1
Enter Transmitter Number (1-65534). Then (#)
2
Enter Facility Code (0-255). Then (#)
3
Important: Steps 1-6 must be performed for EACH Transmitter assigned.
Example:
1
Activates transmitter number "34430", facility code "3", sequence code "2", ID number "4" and button "1".
NOTE: To replace a lost transmitter first delete the lost transmitter (Step 100 on page 47) and
then add the new transmitter to the unit's database (Step 90 on this page).
NOTE: The new card uses the default settings for active and inactive values. To modify these
settings use Step 98 on page 48.
PASSPORT
S W I D SE Q F C PIN
1- 3 0 3 0 0 03 4 12241
4 0 3 0 0 16 3 45009
90
Then
2
Page 45
Sequence Code
Facility Code
Transmitter Number
Button Opens Relay For Door
1
2
3
4
Enter Sequence Code (0-2). Then (#)
4
Enter ID Number (0-26). Then (#)
5
Enter Button Number (1-4). Then (#)
6
3
4
1
2
3
4
5
6
Advertisement
Table of Contents
