Table of Contents
Advertisement
A resident may use a Passport radio frequency transmitter (remote) to
enter a controlled area. When pressed, the transmitter sends a signal to
the unit. It reads this data and determines the validity of the code. If the
code is valid, the unit will activate the device(s) connected to it based on
the button pressed. For example, if a vehicle gate was door 1 and a
pedestrian gate was door 2 then press button 1 on a transmitter to open
the vehicle gate and button 2 to open the pedestrian gate.
Before adding or modifying transmitters, answer the following questions:
•
Do you know the transmitter's codes? Each transmitter will have a transmitter number,
facility code, sequence code, and ID code. These codes can be found on the label located
on the back of the transmitter (refer to illustration on next page).
•
Which schedules will the transmitter use at each door? You may assign a schedule to
each door that a transmitter is assigned to.
•
Will you activate or deactivate the transmitter at a certain day and time? You may assign
a transmitter to a resident and delay its use until a day and time you specify. Also you can
deactivate the transmitter on a specified day and time.
• A transmitter's buttons correlate with the door it will open. For example, Button 2 on the
transmitter activates relays associated with Door 2.
Transmitters
About Transmitters (Remotes)
3
Unit Sends Command to Open Gate
Page 44
1
Transmitter sends Signal to Antenna
2
Unit Receives Signal from Antenna
Advertisement
Table of Contents
