Add, Edit Or Delete Transmitter Codes - Chamberlain Elite EL Series Programming Manual

When adding or editing transmitter codes, note the following:
• The label on the back of the transmitter displays the codes necessary to program the transmitter.
ID Number
Button Number
Codes for Buttons 1-3
Codes for Button 4
• Keep a record of each transmitter code you assign; in particular, write down the resident names
associated with each transmitter. This will help when adding, editing, or deleting transmitter codes
later.
• Once the ID number, sequence, facility and transmitter number are programmed use the chart in the
illustration.
• When adding transmitters buttons 1-3 are automatically entered and active. You do not have to repeat
a step for buttons 2 and 3.
Add a Basic Transmitter:
Add a Basic transmitter to the system's database. A basic transmitter will be active,
unlock all doors/gates assigned to the RF module with no time constraints (i.e., can be
used 24 hours a day, 7 days a week). For Full Function transmitters (i.e., transmitters
with additional options such as schedules, assignments per door), see next page.
Press
1
Enter Transmitter Number (1-65534). Then (#)
2
Enter Facility Code (0-255). Then (#)
3
Important: Steps 1-6 must be performed for EACH Transmitter assigned.
Example:
1
Activates transmitter number "34430", facility code "3", sequence code "2", ID number "4" and button "1".
NOTE: To replace a lost transmitter first delete the lost transmitter (Step 100 on page 47) and then add the
new transmitter to the unit's database (Step 90 on this page).
NOTE: The new card uses the default settings for active and inactive values. To modify these settings use
Step 98 on page 48.
Add, Edit or Delete Transmitter
PASSPORT
SW ID SEQ FC PIN
1-3 03 00 03412241
4 03 00 16345009
90
Then
2
Page 45
Sequence Code
Facility Code
Transmitter Number
Button Opens Relay For Door
1
2
3
4
Enter Sequence Code (0-2). Then (#)
4
Enter ID Number (0-26). Then (#)
5
Enter Button Number (1-4). Then (#)
6
3 4
1
2
3
4
5 6