Table of Contents
Advertisement
II. PROGRAMMING
How to read the LCD:
If the door control utilizes monitoring, monitoring must be turned off in the door control as
1)
Program the hub according to desired settings.
MENU1 (BASIC menu) items MUST be programmed (see page 11).
2)
The network icon will appear for approximately five seconds and then it will return to the Teach-in
screen. The hub LED will display flashing blue and solid orange, and the sensor LED will display flashing
red/green.
CAUTION: No safety present during Teach-in cycle.
3)
Verify that the Home Switch is making/breaking within a few degrees of door movement by observing
the orange hub LED. The Home Switch sensitivity should be set as high as possible.
4)
Push and hold the adjustment knob for three seconds until the blue LED begins flashing. Follow
instructions on the screen, observing the countdown.
5)
For dual-egress doors, push the right door (Door B) open at least 10 degrees when prompted.
75.5753.21 LZR-MICROSCAN T 20210628
- Act = Activation
Saf = Safety
S1 = Stall (door 1)
S2 = Stall (door 2)
- When a parameter is
highlighted, that is the active
output.
The opposite indicates reverse
logic.
- Factory Value
well as the LZR-MICROSCAN hub prior to the Teach-In.
NOTES
How to navigate through the LCD menu:
- Push the gray adjustment knob to enter
SELECT
the LCD menu.
- Select your language before entering
the first LCD menu. This is available for
the first 30 seconds after power-on of
the hub.
SCROLL
- Scroll through the menu items using
the adjustment knob and push to make
selections.
continued on next page
Page 9 of 16
Advertisement
Table of Contents
