Connecting To Pc; Pc With Ethernet Adapter - D-Link DSL-2750U User Manual

DSL-2750U 3G/ADSL/Ethernet Router with Wi-Fi
and Built-in Switch
User Manual

Connecting to PC

PC with Ethernet Adapter

1. Make sure that your PC is powered off.
2. Connect an Ethernet cable between any of four Ethernet ports located on the back panel of
the router and the Ethernet port of your PC.
3. To connect via 3G network: connect your USB modem to the USB port
panel of the router.
!
If you need to connect or change a USB modem to another one when the router is powered
on, power off the device, connect the modem to the USB port, and power on the router.
4. To connect the router to a DSL line: connect a phone cable between the DSL port of the
router and the ADSL OUT port of the splitter. Connect your phone to the PHONE port of
the splitter. Then connect another phone cable between a phone jack and the ADSL IN port
of the splitter.
5. To connect the router to an Ethernet line: connect the Ethernet cable between any of four
Ethernet ports located on the back panel of the router and the Ethernet line.
6. Connect the power cord to the power connector port on the back panel of the router, then
plug the power adapter into an electrical outlet or power strip.
7. Turn on the router by pressing the ON/OFF button on its back panel.
8. Turn on your PC and wait until your operating system is completely loaded.
6 It is recommended to use a USB extension cable to connect a USB modem to the router.
Page 15 of 138
Installation and Connection
6
located on the back