Connecting To Pc; Pc With Ethernet Adapter - D-Link DSL-2740U User Manual

DSL-2740U Wireless ADSL2+ Router with Ethernet WAN Support
User Manual

Connecting to PC

PC with Ethernet Adapter

1. Make sure that your PC is powered off.
2. Connect an Ethernet cable between any of four Ethernet ports located on the back panel of
the router and the Ethernet port of your PC.
3. To connect the router to a DSL line: connect a phone cable between the DSL port of the
router and the ADSL OUT port of the splitter. Connect your phone to the PHONE port of
the splitter. Then connect another phone cable between a phone jack and the ADSL IN port
of the splitter.
4. To connect the router to an Ethernet line: run the Initial Configuration Wizard and select
the router's LAN port that will be used as the WAN port. Then connect the Ethernet cable
between the selected Ethernet port located on the back panel of the router and the Ethernet
line.
5. Connect the power cord to the power connector port on the back panel of the router, then
plug the power adapter into an electrical outlet or power strip.
6. Turn on the router by pressing the ON/OFF button on its back panel.
7. Turn on your PC and wait until your operating system is completely loaded.
Page 14 of 174
Installation and Connection