9-3.Outline Of The Determination Diagram; 9-3-1.Procedure Of Defect Diagnosis; 9-3-2.How To Determine From The Check Code On The Remote Controller; 9-3-3.How To Cancel A Check Code On The Remote Controller - Toshiba HWS-P805XWHM3-E(TR) Service Manual

9-3. Outline of the determination diagram
The first determination of whether a defective part is in the hydro unit or the outdoor unit can be performed by the
following method.
9-3-1. Procedure of defect diagnosis
In the case of a defect, please apply the following procedure in order to find the defective part.
Confirm the check
Defect
code on the remote
controller display
9-3-2. How to determine from the check code on the remote
controller
If the defect is limited by the check code displayed on the remote controller, please repair the defect based on the
table on the next page.
The check codes are separated into two groups: software and hardware errors.
Since a hardware error cannot be cancelled without a part replacement etc., please perform a repair.
If its abnormality is determined, the abnormality is noticed by indicating the check code on the remote controller
check code display part while sounding off a buzzer.
9-3-3. How to cancel a check code on the remote controller
Press [ ] or [ ] button (on the operation side) to clear the check code.
Although the above procedure cancels the check code, the hardware error will be displayed again until the
hardware repair is completed.
Abnormality in the outdoor unit or hot-water
tank unit
ZONE1 ZONE2
HEAT/COOL
84
Yes
Check code
A01-A13
No
Yes
Check code
L07-L16
No
Yes
Check code
FXX
No
MON
HOT WATER
HOT WATER
Defect in Hydro unit
Abnormality in the
communication or setting
system
Abnormality in the water
heat exchange or outdoor
unit sensor system
Check code display part