Toshiba HWS-P805XWHM3-E(TR) Service Manual page 181

3. Outdoor unit (3 phase type)
HWS-P805H8R-E, P1105H8R-E, P1405H8R-E
MCC-1675(CDB)
 Setting the DIP switches
Parts name
DIP switch SW800
Check the DIP switch according to the following figure. If they are not set correctly, a certain error code appears
on the remote controller and the operation is disabled.
S
MCC-1698
 Installing the PC board
1) Apply thermal greass between HEATSINK and Power Devices (DB01 and Q201) on Compressor PC board.
2) Screw the Compressor PC board to the HEATSINK by the four screws. Do not use an electric driver or an
air driver. As it can cause component damage. The torque of the screws for DB01 and Q201 are "1.2Nm".
Function
Adress setting
180
DIP switch setting：
2
1
ON OFF