Back Panel; Display Panel - RCA VR652HF User Manual

References
Location of Controls

Back Panel

CH3 CH4 Switch
Selects the channel to which you will tune the TV
to see the VCR picture if you connect the VCR
using one of the basic hookups.
IN FROM ANTENNA Connector
Receives the signal from an antenna, cable system,
or satellite receiver that is attached to this
connector.
OUT TO TELEVISION Connector
Passes signal to TV using the cable supplied.

Display Panel

This VCR has a feature where you can change the brightness level of the fluorescent
display panel.
1. Press MENU•PROG on the remote to see the VCR MAIN
2. Press 6 to display the PREFERENCES menu.
3. Press 4 to select Front Panel: AUTO, BRIGHT, or DIM.
44
MONO
L L
R R
IN
IN OUT
AUDIO
MENU on the TV screen.
¥ Select AUTO to keep the display panel bright when VCR
is on and dim when it is off.
¥ Select BRIGHT to keep the display panel bright.
¥ Select DIM to keep the display panel dim.
IN
FROM
ANTENNA
VIDEO
OUT
OUT
TO
TELEVISION
CH
3 4
VIDEO and AUDIO (R and L MONO) IN Jacks
Receives signals from another component, like
a VCR or camcorder, when it is connected to
these jacks. Use INPUT to select L1 in the
VCRÕs display panel.
Attach a component that is not stereo to the L
MONO jack to hear sound on both channels.
VIDEO and AUDIO (R and L) OUT Jacks
Sends signals from VCR to another component,
like a TV monitor or VCR, when it is connected
to these jacks.
VCR MAIN MENU
1 VCR Plus+
2 Timer Recordings
3 Time
4 Channels
5 Setup
6 Preferences
PREFERENCES
1 Remote Control: VCR1
2 Auto Play: ON
3 Auto TV/VCR: ON
4 Front Panel: AUTO
5 CA Marking: ON
6 CA Playback: AUTO
7 CA Display: BLUE
0 Exit
continued on next page