Using The Remote Control; Satellite Receiver Buttons; Component Buttons; Vcr Function Buttons - RCA VR652HF User Manual

Using the Remote Control

Remote Control
Your back-lit remote has a light button (
buttons remain lit when they are pressed within a few seconds of each other. If a button is not pressed within approximately ten
seconds, the light turns off to conserve battery power.
Note: Home system
theatre users Ñ press
PWR twice to turn off all
RCA brand components.
1
DV
PWR
2 2 2
REW PLAY
REC
STOP
DISPLAY
MUTE
1 2
4
5
7
8
INPUT
0
•
CLEAR
C M
SLOW
3
_
+
F.ADV
16
) that glows in the dark. Press this button to light the buttons on the remote. The remote

Component Buttons

Press one of the buttons to set the remote to operate that component.
AUX (Auxiliary)
Can be programmed to control a
compatible RCA audio or video
component. See page 21.
SAT•CABLE
Turns on a compatible cable box or
satellite receiver. See page 20.
Used with PWR button to turn on
another brand of cable box or
receiver, other than RCA, when the
remote is programmed to control
that cable box or receiver. See
page 20.
TV
TV
Turns on a compatible RCA,
FF
ProScan, or GE TV and sets the
remote to control the TV.
PAUSE
SEARCH

VCR Function Buttons

Press VCR1 (VCR2•LD) to set remote to control the VCR to use the function buttons.
CHAN Up or Down
PREV CH
Selects next higher or lower channel
in the VCRÕs channel memory.
3
CLEAR
6
Resets time counter to 0:00:00.
9
Allows you to change entries when
setting the clock or VCR for a VCR
TV•VCR
Plus+ or timer recording.
SPEED
DISPLAY
Shows VCR operating displays on
the TV screen.
TRACKING
4
Displays program information
when available.
EDIT
e
Displays the time counter.
EDIT
Signals two properly connected
compatible VCRs to begin copying
a tape. See page 42.
F.ADV (Frame Advance)
Lets you view one frame with each
press of the button while the tape is
paused.
FF (Fast Forward)
Fast forwards the tape when the
VCR is stopped.
Used with PWR button to turn on
another brand of TV, other than
RCA, when the remote is
programmed to control that TV.
See page 19.
VCR1
Turns on a compatible RCA,
ProScan, or GE VCR and sets
remote to control the VCR.
VCR2•DVD
Turns on a compatible RCA,
ProScan, or GE VCR and sets
remote to control VCR when it has
been setup. See page 18.
Used with PWR button to turn on a
compatible RCA or ProScan
LaserDisc player. See page 18.
Can also be programmed to control
a compatible RCA DVD component.
Searches the picture in forward
motion during playback.
INPUT
Turns the line input on or off.
L1 will appear in the VCRÕs display
panel and VIDEO will appear on the
TV screen.
Line input refers to the signal
coming from the component
connected to the audio/video input
jacks on the back of the VCR.
MENU•PROG
Displays the VCR MAIN MENU on
the TV screen.
Removes a menu from the screen.
Numbers (0 through 9)
Select a channel up to 99 by
pressing two numbers.
Select a cable channel over 99 by
pressing and holding 1 until 1– –
appears on the screen. Then press
the other two numbers.
PAUSE
Pauses action for viewing during
playback.
Pauses recording to prevent
recording of unwanted scenes.