Satellite Receiver - RCA VR652HF User Manual

Hooking Up the VCR

Satellite Receiver

Position Satellite Receiver
Do not stack electronic components or other objects on top of the receiver. The slots on top of the receiver
must be left uncovered to allow proper airflow to the unit. Blocking the airflow to the unit could impair
performance or damage your receiver and other components. Also, do not stack the receiver on top of a
Òhot componentÓ such as an audio power amplifier.
A. Basic hookup.
Use this hookup if your TV does not have
audio/video jacks.
1. Set the CH3 CH4 switch on back of
satellite receiver to either channel 3 or 4.
You will tune the VCR to this channel or its line
input (L1) to record from the receiver.
To watch the satellite receiver, turn off the VCR.
If you want to watch or record the signal from
your antenna, cable, or cable box, make sure the
satellite receiver is turned off.
2. Set the CH3 CH4 switch on back of VCR
to either channel 3 or 4.
You will tune the TV to this channel and use the
TV•VCR button to watch the VCR.
3. Connect as shown.
This connection may require additional
accessories not provided.
4. Plug in power cords of VCR, TV, and
receiver.
Continue to page 9.
5.
Caution: The unauthorized recording
of satellite broadcasts, television
programs, or other materials may
infringe the rights of others.
6
A
From
Cable, Cable Box
or Antenna
Back of Satellite Receiver
CH3
CH4
IN FROM ANT
OUT TO TV
S-VIDEO
Audio/Video Cables
(supplied)
MONO
L
R
IN
AUDIO
Back of VCR
75 to 75/300 Ohm
Separator
From
Satellite
Dish
SATELLITE IN
VIDEO R AUDIO L
RF Coaxial Cable
IN
FROM
L
ANTENNA
VIDEO
R
OUT
IN OUT
TO
OUT
CH
TELEVISION
3 4
RF Coaxial Cable
(supplied)
VHF
OR
Cable/
Antenna
UHF
Back of TV