Table of Contents
Advertisement
Optimizing the Network Adapter used with Linea2
5GigE
Most Gigabit network interface controllers (NIC) allow user modifications to parameters such as
Adapter Buffers and Jumbo Frames. The optimal settings will be system dependent. These should
be optimized for use with the Linea2 5GigE during installation; refer to Teledyne DALSA's Network
Imaging Package for Sapera LT Optimization Guide for more information.
Running the Network Configuration Tool
The Network Configuration tool provides access to NIC and connected GigE Vision camera
parameters without use of any Windows Control Panel application.
This tool allows you to:
•
Activate the Network Imaging driver use for image acquisition on any NIC or disable the
imaging driver for any NIC not used with a GigE Vision camera.
•
Configure the NIC as a DHCP server for connected GigE Vision camera.
•
Change the Auto Discovery Interval from the default of 15 seconds.
•
Configure the NIC and camera IP settings.
•
Assign a User Defined name to a connected camera.
•
Assign a Persistent IP address to a camera instead of the default DHCP/LLA assigned address.
Important: Changes made with this tool may update Linea2 5GigE parameters
stored in flash memory. Do not remove power from the camera for a minimum 10
seconds.
Refer to Teledyne DALSA's Sapera LT Getting Started Manual for GigE Vision Cameras & 3D
Sensors for more detailed information on using this tool. The Network Configuration tool can
quickly verify and modify certain network configuration items of the imaging system.
Linea2 5GigE Series Camera
Figure 78: Network Configuration Tool
Network Overview & Tools • 123
Advertisement
Table of Contents
