Table of Contents
Advertisement
tank (5)
(5)
(5)
(5) runs out of water, disconnect the appliance from the
(5)
mains outlet, wait till it cools down, refill the tank and plug the
appliance back into the power supply and continue the process.
Using the water spray (7)
article (cuffs, trimmings, plackets, etc) or clothes, which demand
«•» (low temperature) ironing, when steam ironing is not possible.
Push the button several times to moisten the material.
5. When you have finished cleaning or ironing, do not forget to
switch the iron off by putting the steam control knob (9)
temperature control knob (10)
plugging the appliance from the mains supply outlet.
CARE AND MAINTENANCE
! The scale on the sole plate can be removed
! Do not use any abrasive substances and ma-
Cleaning of internal parts of the appliance
SI-2550 iron is equipped with an anti-scale function which
protects it from an accumulation of scale: it does this with a built-in
permanent filter. Therefore the water hardness is reduced and the
useful service life of the iron is extended.
Warning: In areas with very hard water it is recommended
that you regularly remove scale from the appliance to
maintain it in good working order. Excess lime scale
may result in damage or malfunction of your product.
If in your area the water is soft and you have average amounts
of clothes to be ironed then we recommend you to de-scale every 6
months. If the water in your area is very hard or if you iron fre-
quently, then we recommend you de-scale once a month.
Your iron has a self-cleaning function, which allows you to clean
the internal parts of the appliance from scale or dust. To use this
function perform the following procedure:
1. Set the steam control knob (9)
(5)
(5)
2. Fill the tank (5)
(5)
(5) with water to the «Max» level.
3. Place the iron in a vertical position and plug it into the mains
supply outlet.
4. Set the temperature control knob (10)
The light indicator (11)
being heated to the desired temperature.
5. When the iron reaches the maximum temperature, the light
indicator (11)
(11) will go out.
(11)
(11)
(11)
6. Whilst holding the appliance horizontally over a sink, set the
steam control knob (9)
steam will discharge from the sole plate (12)
Spray
(7)
(7)
(7)
(7) will help when ironing details of the
(10)
(10)
(10) into the «0» position and un-
(10)
Cleaning of the sole plate
with a rough cotton cloth dampened with a
vinegar solution.
terials to clean the sole plate.
(9)
(9)
(9) into the «0» position.
(9)
(10)
(10)
(10) into the «Max» position.
(10)
(11)
(11)
(11) will light up showing that the iron is
(11)
(9)
(9)
(9) into the «Self-Clean» position. Hot
(9)
6 6 6 6 6
(9)
(9)
(9) and the
(9)
(12)
(12) removing the
(12)
(12)
Advertisement
Table of Contents
