Installing The Wall-Mount Housing - Endress+Hauser Proline Promass 83 Operating Instructions Manual
Coriolis mass flow measuring system
Hide thumbs
Also See for Proline Promass 83:
- Manual (200 pages) ,
- Function manual (192 pages) ,
- Operating instructions manual (178 pages)
Table of Contents
Advertisement
Proline Promass 83 MODBUS RS485
"
Endress+Hauser
3.3.2
Installing the wall-mount housing
There are various ways of installing the wall-mount housing:
• Mounted directly on the wall
• Installation in control panel (separate mounting set, accessories) → Page 22
• Pipe mounting (separate mounting set, accessories) → Page 22
Caution!
• Make sure that ambient temperature does not go beyond the permissible range
(– 20 to +60 °C (–4 to + °140 F), optional – 40 to +60 °C (–40 to +140 °F)). Install the device
in a shady location. Avoid direct sunlight.
• Always install the wall-mount housing in such a way that the cable entries are pointing down.
Mounted directly on the wall
1.
Drill the holes as illustrated in the diagram.
2.
Remove the cover of the connection compartment (a).
3.
Push the two securing screws (b) through the appropriate bores (c) in the housing.
– Securing screws (M6): max. Ø 6.5 mm (0.26")
– Screw head: max. Ø 10.5 mm (0.41")
4.
Secure the transmitter housing to the wall as indicated.
5.
Screw the cover of the connection compartment (a) firmly onto the housing.
90 (3.54)
Fig. 13:
Mounted directly on the wall
35 (1.38)
b
c
a
Installation
c
192 (7.56)
mm (inch)
a0001130
21
Advertisement
Table of Contents
