HPRT HN-3358SR - Handheld Barcode Scanner Manual

Appearance

1. Sound Hole
2. Scan Window
3. Scan Button
4. Indicator
5. Type-C
6. Shutdown Hole

Power on/off and Restart

• Start up:

1. Automacally start up aer connecng USB;
2. When USB is not connected, press the scanning buon to start the scanner.

• Shut down:

1. Press and hold for 15s to shut down;
2. Shut down automacally aer 15 minutes of silence (without any touch).

• Restart:
  If the scanner crashes or does not response, press the boom switch with the paper clip. Then press the scanning buon to restart.

Maintenance

• The reading window must be kept clean.
• Avoid hard and rough objects to scratch the reading window.
• Remove the stains from window with a brush.
• Please use a so cloth to clean the window, such as glasses cloth.
• Do not spray any liquid on the window
• Do not use any cleanner other than cleaning water.

Bluetooth Connection

The scanner is shut up by pressing the scanning buon, and be connected it to the host devices through Bluetooth. The green light indicates that it is connected and can be used normally.

1. Set shut down/up me
   
2. Pop up iPhone keyboard by Bluetooth
   

USB Connection

1. Connect the device interface (type-C interface) of USB to scanner;
2. Connect the host interface (USB interface) of USB to the host and switch to the keyboard mode.

Buzzer

LED Indicator

Interface Setting

The scanner can communicate with the host by RS-232 serial port or USB port. The user can switch to the corresponding interface by replacing the cable and scanning the corresponding barcode below.

1. USB virtual keyboard
   
2. USB virtual Serial Port
   
3. Bluetooth
   

Set Defaults

Scan the barcode to restore all settings to the factory default state.

Note: Please use the "factory reset" funcon carefully. Aer recognizing this barcode, the current parameter settings will be lost and replaced with the factory default values.

Scanning Mode

• Scan mode settings by scanning the barcode below

1. Manual Mode
   
2. Sensing Mode
   
3. continuous Mode
   

• Other

1. Aiming Barcode
   
2. Read Successfully Barcode
   

Common Problem

There are some barcodes can not be scan

1. Firstly, check the barcode type and enable the barcode funcon; if there is verified, try to close the verificaon.
2. Unable to know the barcode type, then set all barcodes allow to be read.

The barcode data is incorrect

Check the status of barcode errors (whether all barcodes have errors or specific barcodes have errors)

Bar code can be read but not displayed

First, confirm whether the working mode of the scanner is in Bluetooth transmission mode; if it is already in Bluetooth transmission mode, confirm whether the Bluetooth of the scanner is connected to the host terminal.

Aiming light and illumunation light are not on

1. Check whether the device is powered on.
2. Re-plug the data cable.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download HPRT HN-3358SR - Handheld Barcode Scanner Manual