Wittkopp Primor P30 Series User Manual

Primor
User manual
Brief instructions for the daily user
Note:
On the cover sheet you can find warning information, and an explanation of the symbols
and terms used, together with the exclusion of liability.
Contents
General ........................................................................................................................... 1
Opening .......................................................................................................................... 2
P1000 / P1600 ............................................................................................................. 2
P2000 / P2600 ............................................................................................................. 2
P30xx .......................................................................................................................... 2
Opening with dual code ................................................................................................... 3
Opening with active delay time ........................................................................................ 3
Triggering a silent alarm .................................................................................................. 4
Menu functions ................................................................................................................ 4
0 Change code ............................................................................................................ 4
Replacing the battery ...................................................................................................... 5

General

Depending on the setup, the opening of the lock can be subject to additional restrictions.
A combination of these restrictions is also possible:
1. Delay time → Opening is only possible once a defined delay time has come to the
end (with the exception of user 9).
2. Dual code → Opening is only possible with two valid user codes.
Normally each user code has a length of 6 digits (0-9) [level 5]. If a silent alarm has been
configured, the number of code digits is increased to 7 places. The 7th code digit is
therefore shown in grey in the following description. It is triggered by changing the last
code digit.
The dual code / "two pairs of eyes" principle [level 25] as well as the alarm function [level
15, 25] are activated in the factory and cannot be disabled by the user.
Ask you administrator (master code) how your system has been set up.
en_04 Pxxxx - User manual V2.03 1 / 5