Table of Contents
Advertisement
CF-SPAKER Installation
1. Make sure the valve is in the OFF
position before beginning.
2. Install CF-SPARKER as shown, using
a AAA battery (not included).
Negative end should be placed
inside the CF-SPARKER, positive end
outside of the CF-SPARKER.
CF-SPARKER will not operate correctly without an ignition and ground
wire attached.
Plug both BLACK wires hanging from the burner into the back of
the sparker box.
Before turning on gas, test CF-SPARKER by pushing the button
on the igniter. Consult the troubleshooting section of the
Crystal Fire Owner's Manual if the spark is weak, intermittent,
or not present.
OFF
9
Advertisement
Table of Contents
