Advertisement
Quick Links
Advertisement
Related Manuals for Outdoor GreatRoom Company Stonefire SF-32-K
Summary of Contents for Outdoor GreatRoom Company Stonefire SF-32-K
- Page 1 Stonefire Fire Pit Table Installation Instructions for SF-32-K...
-
Page 3: Table Of Contents
IMPORTANT Please consult your Crystal Fire instruction manual for detailed instructions and important information related to the burner installation including: lighting and operating instructions, safety information, and proper tightening of connections with two wrenches. DO NOT ATTEMPT TO INSTALL CRYSTAL FIRE BURNER WITHOUT FIRST CONSULTING THE CRYSTAL FIRE OWNER’S MANUAL. -
Page 4: Included With Your Fire Pit
Included with your Fire Pit Bolt Cap Clear Silicone Pads Gas Valve Kit [X4] [X4] Mounting Gas Valve [X1] screws [X2] Bolt A [X4] M6 Allen Wrench Control knob [X1] [X1] M6X20 Top [X1] Glass Cover [X1] Base [X1]... -
Page 5: Assembly Instructions
Assembly Instructions Included with your Fire Pit 1. Unpack all the contents from the box and remove the individual packaging from each component. A. 4 Fasteners 2. Carefully lay the Top, with underside facing upwards, on a soft and flat B. - Page 6 5. Hold the Gas Valve in place from behind the control panel as shown while inserting the two included Mounting Screws. Use a Phillips screwdriver to fasten. Insert screws included with Gas Valve Kit 6. Attach Control Knob by pressing on to the valve stem.
-
Page 7: Gas Connections
Gas Connections Read and understand your Crystal Fire owner’s manual before beginning burner hookups or using the device. Do not use Teflon tape or pipe dope on flare fittings. 1. Reach inside the burner cut-out and attach natural gas supply line using a 3/8”... - Page 8 3. Set Burner into the fire pit base as shown below. Igniter Access Door 4. Attach flex line from the burner to gas valve as shown below. TIGHTEN CONNECTION SECURELY WITH WRENCH Metal flex line to burner ONLY...
-
Page 9: Igniter Installation
Igniter Installation 1. Make sure the valve is in the OFF position before beginning. 2. Install sparker as shown, using a AAA battery (not included). Negative end should be placed inside the CF-SPARKER, positive end outside of the CF-SPARKER. Sparker will not operate correctly without an ignition and ground wire attached. -
Page 10: Glass Installation
Glass Installation 1. Scatter all of the included Glass Beads evenly onto burner surface. DO NOT OPERATE CRYSTAL FIRE BURNER WITHOUT GLASS BEADS OR OTHER DECORATIVE MEDIA PRESENT 2. Attach the Clear Silicone Pads (x4) to the bottom of your Glass Cover. -
Page 11: Position Your Tank
After installing sparker and making gas connections, verify that all connections are tight and that no leaks are present using a solution of soapy water or a commercially available leak-check solution. Position Your Tank (if applicable) 1. Connect the propane hose/regulator to the propane tank and hand tighten (DO NOT USE A WRENCH) and slide the propane tank past the dotted line to ensure the Access Door closes properly. - Page 12 IMPORTANT Please consult your Crystal Fire instruction manual for detailed instructions and important information related to the burner installation including: lighting and operating instructions, safety information, and proper tightening of connections with two wrenches. DO NOT ATTEMPT TO INSTALL CRYSTAL FIRE BURNER WITHOUT FIRST CONSULTING THE CRYSTAL FIRE OWNER’S MANUAL.
Need help?
Do you have a question about the Stonefire SF-32-K and is the answer not in the manual?
Questions and answers