INSTALL NOTE:
installation of all panels.
A. 4 Fasteners
1. Unpack all the contents from the box and remove the individual
B. 4 B-Bolts
packaging from each component.
C. 4 C-Bolts
2. Carefully lay the Top, with underside facing upwards, on a soft and flat
D. 4 Bolt Caps
surface. Attach Attachment Bracket (X1) using Bolt A (X1) to corner as
E. Touch-Up Paint Bottle
shown below. Repeat process for each corner of table.
1. Unpack contents from box, and remove individual packaging from each
piece.
2. Lay Side Panel with Control Panel on soft, flat surface.
3. Position Support Piece on the Side Panel. NOTE: It is very important to
positon the Support Piece as shown in the picture below, to ensure that
your burner and propane tank fit correctly with your fire pit table base.
3. Attach Panel A using Bolt A (X2) to Attachment Brackets as shown
below.
4. Attach Panel B on the opposite side of Panel A using Bolt A (X2)
55
as shown below.
Assembly Instructions
Included with your Fire Pit
Final tightening of bolts should be completed following
Assembly Instructions
4