Nikon Z8 User Manual page 459

Tip: Suspending Synchronized Release
To temporarily disable synchronized release without ending the camera's connection to the network,
select [OFF] for [Connect to other cameras] > [Synchronized release] in the network menu.
Tip: Viewing Remote Camera Status
To view remote camera status, highlight [Remote camera list] on
the master camera and press 2.
Remote cameras are identified by IP address.
Remote camera status is displayed as follows:
- [Connected]: Normal connection.
- [Busy]: The camera is being controlled from another master
camera.
- [Error]: One of the following errors has been detected:
- The remote camera standby timer has expired.
- The remote camera is off.
- The remote camera is not in the same group as the master
camera.
- The IP address is incorrect.
- [OFF]: Either
- no remote camera has been assigned to the slot, or
- [OFF] is selected for [Connect to remote camera] on the
camera in question.
Highlighting a remote camera with the [Connected] label and
pressing 2 displays the number of pictures awaiting upload
from the camera via FTP, FTP connection status, the battery level,
and the number of exposures remaining.
The entries for the remote cameras previously used for
synchronized release will show the time of the most recent shot.
To edit remote camera settings from the master camera,
highlight the camera in the remote camera list and press 2.
- To temporarily suspend the connection to the selected
camera, select [OFF] for [Connect to remote camera].
- To temporarily suspend synchronized release on the selected
camera, select [OFF] for [Synchronized release].
- If desired, you can then edit the camera's IP address by
highlighting [Address] and pressing 2. To reconnect, select
[ON] for [Connect to remote camera]. No connection will
be established if no remote camera exists at the specified
address.
385
Synchronized Release