GeoVision GV-MFD320 Quick Start Manual page 254

IMPORTANT:
1. If Dynamic IP Address or PPPoE is enabled, you need to know
which IP address the camera will get from DHCP server or ISP to
log in. If your camera is installed in the LAN, use the GV-IP Device
Utility to look up its current dynamic IP address. See 21.2.1
Checking the Dynamic IP Address in the Quick Start Guide. If your
camera uses a public dynamic IP address via PPPoE, use the
dynamic DNS Service to obtain a domain name that is linked to the
camera's changing IP address first. For details, see LAN
Configuration and Advanced TCP/IP sections, Administrator Mode
Chapter in the GV-IPCAM H.264 Firmware Manual on the Software
DVD.
2. If Dynamic IP Address or PPPoE is enabled and you cannot
access the camera, you may have to reset the camera to its factory
default and then perform the network settings again. To restore
factory settings, see 24. Restoring to Default Settings in the Quick
Start Guide.
21
Accessing the Camera
219