Table of Contents
Advertisement
Troubleshooting
If you forgot your password, you must reset your access point. Unfortunately, this process will change all your settings back to the factory
defaults.
To reset the access point, locate the reset button (hole) on the rear panel of the unit. With the access point powered on, use a paperclip to hold
the button down for 10 seconds. Release the button and the access point will go through its reboot process. Wait about 30 seconds to access the
access point. The default IP address is 192.168.0.50. When logging in, the username is admin and leave the password box empty.
After you install your network adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP server (i.e. wireless
router) automatically. To verify your IP address, please follow the steps below.
1. Click on Start > Run. In the run box type cmd and click OK.
2. At the prompt, type ipconfig and press Enter.
This will display the IP address, subnet mask, and the default gateway of your adapter.
If the address is 0.0.0.0, check your adapter installation, security settings, and the settings on your router. Some firewall software programs
may block a DHCP request on newly installed adapters.
If you are connecting to a wireless network at a hotspot (e.g. hotel, coffee shop, airport), please contact an employee or administrator to verify
their wireless network settings.
D-Link DAP-2620 User Manual
What can I do if I forgot my password?
How to check your IP address?
91
Advertisement
Table of Contents
