Midea MAP10S1CWT User Manual page 10

Other Features
FOLLOW ME/TEMP SENSING
Feature (optional)
NOTE
This feature can be activated from the remote control ONLY. The remote control serves
as a remote thermostat allowing for the precise temperature control at its location.
To activate the Follow Me/Temp Sensing feature, point the remote control towards
the unit and press the Follow Me/Temp Sensing button. The remote display is actual
temperature at its location. The remote control will send this signal to the air conditioner
every 3 minutes until the Follow Me/Temp Sensing button is pressed again. If the unit
does not receive the Follow Me/Temp Sensing signal for 7 minutes, the unit will beep to
indicate the Follow Me/Temp Sensing mode has ended.
AUTO-RESTART
If the unit shuts off unexpectedly due to a power outage, it will restart with the
previously set function automatically when the power resumes.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
After the unit has stopped, it cannot be restarted until 3 minutes have elapsed. This is
to protect the unit. Operation will automatically resume after 3 minutes.
AIRFLOW DIRECTION ADJUSTMENT
The louver can be adjusted automatically, which also automatically adjusts the airflow
direction.
NOTE
On some models the louver can be adjusted manually only):
• When the Power is ON, the louver opens fully.
• Press the SWING button on the panel or remote control to initiate the Auto Swing
feature. The louver will swing up and down automatically.
• If your unit has these features, please do not adjust the louver manually.
• If your unit does not have these features, the louvers may only be adjusted manually
Remove the
upper drain
plug
Continuous
drain hose
√
Page 10
Water drainage
• During dehumidifying modes, remove the upper
drain plug from the back of the unit and install the
drain connector (5/8" universal female mender) with
3/4" hose (locally purchased). For models without
drain connector, just attach the drain hose to the
hole. Place the open end of the hose directly over
the drain area in your basement floor.