Table of Contents
Advertisement
[Setup via recorder's main monitor]
Configure the advanced settings for recording and events [Advanced setup]
Configure the special settings related to recording on this tab. Set up the recording mode, alarm disarm dura-
tion and Panasonic alarm port number (the port number for incoming site alarm).
[Recording mode]
Determine whether or not to stop all recording
actions. Set to "Off", primarily to stop access to the
HDD before turning off the power.
On: Performs recording.
Off: Stops all recording actions.
Default: On
Important:
• If "Off" is selected, be sure to return the setting to
"On" when resuming operation.
[Alarm disarm duration]
Set the period to suspend event actions for the case
that the same kind of event (terminal alarm, camera
site alarm, command alarm) occurs repeatedly at the
same camera.
2 s/ 3 s/ 5 s/ 10 s
Default: 2 s
[Panasonic alarm port number]
Specify the number of the port to be used for receiv-
ing site alarm.
Default: 1818
Note:
• Enter the port number in five digits, right aligned.
(Example: When the port number is 80, enter
"00080".) The leading zeros are omitted here.
• The following numbers, the HTTP port number, the
HTTPS port number, the FTP port number and the
port number of the port forwarding are unavailable.
20, 21, 23, 25, 42, 53, 67, 68, 69, 79, 80, 105, 110,
123, 161, 162, 443, 546, 547, 995, 10001, 10002,
10003, 10004, 10005, 10006, 10007
[Recording time of emergency recording]
Select a recording duration for the emergency recording.
30 s/ 1 min/ 3 min/ 5 min/ 10 min/ 15 min/ 30 min
Manual: Records only while the connected exter-
nal switch is being pressed. It records at least
8 seconds.
Ext.: Alarm output will continue until the alarm
action is reset. Refer to the "Cancel the alarm
action" (☞ Page 129) for further information
about how to cancel the alarm action.
Default: 30 s
[External recording setup]
Select the schedule of the external recording.
The following screen of the external recording setting
will be displayed when [Setup >] button is clicked.
Select schedule settings that you want conduct for
each camera on [External recording setup].
Off/Schedule1 ~ Schedule16
Default: Off
Note:
• When many cameras are registered, the switcho-
ver of the schedule may be delayed due to the
external recording input.
[SD backup rec.]
Set whether to save the image on the SD memory
card or not when the communication is disconnected
during the recording.
44
Advertisement
Table of Contents
