Initialize Element Status Command (07H); Figure 6 Initialize Element Status Command - Quantum SuperLoader DLT User Manual

Initialize Element Status Command (07h)

Figure 6 Initialize
Element Status
Command
Bit
Byte 7
0
Logical Unit Number
1
2-4
Unused
5
The INITIALIZE ELEMENT STATUS command allows the media
changer to check all assigned element addresses for volume and
any other status relevant to that element address. The intent of this
command is to enable the Initiator to get a quick response from a
subsequent READ ELEMENT STATUS command. It may be useful
to issue this command after a power failure, if a volume has been
changed by an operator, or if configurations have been changed.
6 5
Operation Code (07h)
Quantum ATL SuperLoader Software Interface Guide
Chapter 3 Media Changer Commands
Initialize Element Status Command (07h)
4 3
Reserved
Reserved
2 1
Reserved
Flag
3
0
Link
31