How To Change Various Setting - Sharp Plasmacluster DW-J27FV Operation Manual

OPERATION

HOW TO CHANGE VARIOUS SETTING

You can change the functions in the table "Type of setting".
1.
Turn off the Main Unit power.
♪
2.
more 3 sec.
3.
Select "Function number".
Forward
♪
or
････
Set
4.
Select "Setting number".
Forward
♪
or
Set
5.
Press Power ON/OFF Button to
finish the setting mode.
♪
～
Turn off
Type of setting
Auto Restart
If the Main Unit is
unplugged or if there is a
power failure, the Main Unit
will resume operation with
the previous settings after
power is restored.
Reverse
Sound Indicator Setting
You can turn off the beeping
♪
sound when the Main Unit
stops operating as follows.
When the Main Unit stops
operating as the following
situation, you can turn off
the beeping sound.
♪
Light Control
You can select the
brightness of the Front
Display.
Reverse
♪
PLASMACLUSTER ION
ON/OFF
♪
Auto Off
The operation will stop
automatically after 12 hours in
case the Main Unit has been
forgotten to be turned off.
Adjusting Sensor Sensitivity (F6-F8)
Light Sensor
Dust(sensitive)
Sensor
Odor Sensor
EN-10
Function
* Light Sensor : Default is "Middle".
Dust(sensitive) and Odor Sensor : Default is "High".
Setting
Cancellation
ON
(default)
Cancellation
ON
(default)
Turn off
When set to "Turn off", the
"Darker" light illuminates for 8
seconds after operation starts
and then the light turns off.
The FULL Light flashes darker
only when the Water Tank is full.
Darker
Auto
(default)
Light automatically switches
based on room brightness.
Room Front Display
bright brighter
dark darker
* When "SLEEP" mode operate;
Room is bright : light is darker
Room is dark : light is OFF
OFF
ON
(default)
Cancellation
ON
(default)
Low
Standard
(default)
High