Table of Contents
Advertisement
OPERATION
MOLD CONTROL OPERATION
This mode is used to suppress the mold through
strong air flow with Plasmacluster Ion.
When turned ON, it firstly starts ventilation for 10
minutes with maximum air flow, and then repeats
following operation.
(Cleanliness monitor shows actual operating mode.
Purple: high air volume, Blue: low air volume.)
It operates automatically the Plasmacluster Ion
"ON".
In high humidity
It operates in "HIGH" mode of dehumidification
until the humidity of the room decreases to
the level in which the mold is less likely to
appears.
In low humidity
Once the humidity in room becomes low, the
model switches the operation with maximum
airflow.
【for about 80 minutes】
(Cleanliness Monitor: blinking with Purple)
※ Operating time depends on the room environment,
usage conditions, and location of the Main Unit.
NOTE
• When the air in the room is purified and the humidity
becomes low, the main unit operates with "Low" air
flow. (Cleanliness Monitor : lighting in Blue)
• If the humidity becomes high again, it will switch to
the above operation under the condition of "in a high
humidity".
TIMER OPERATION
ON TIMER
The Main Unit automatically starts once the
selected time passes.
(with the Main Unit OFF)
♪
♪
1hour
2hour
3hour
After 8 seconds, the beep sounds.
OFF TIMER
The Main Unit automatically stops once the
selected time comes.
(with the Main Unit ON)
♪
♪
1hour
2hour
3hour
After 8 seconds, the beep sounds.
EN-8
Front Display
♪
♪
♪ ♪
......
12hour
Cancel
Front Display
♪
♪
♪ ♪
......
12hour
Cancel
Advertisement
Table of Contents
