EZVIZ LC1 - Smart Security Light Camera Manual

Also See for LC1:

Quick start manual (33 pages)

Table of Contents

Contents

1 What's in the Box
2 Floodlight Camera
3 Floodlight Camera Installation
4 Floodlight Camera Setup
5 Install Memory Card (Optional)
6 Initialize Memory Card
7 Documents / Resources
- 7.1 Download manual

EZVIZ LC1 - Smart Security Light Camera Manual

What's in the Box

Floodlight Camera

Floodlight Camera Installation

Shut down the electricity at the breaker that controls floodlight camera's circuit.
Keep the breaker off at any time during the installation process.
Pull the floodlight camera completely off the base.
Unscrew the mounting base screw, then press the bottom button all the way down, and pull the string to take the mounting base off.
Remove your existing floodlight from the junction box.
Disconnect the three sets of wires from the floodlight, if there is any existing mounting bracket attached to your junction, remove that as well.
Install the bracket to the junction box with the mounting screws.
Peel off the white tape from the gasket and stick the gasket to the mounting base.
Ensure the center hole lines up with the center one on the mounting base.
Connect the junction box and floodlight camera 3-wire connector.

Wire from Junction box Connect to Matching Wire on Camera

Green/Copper-Ground Green

Black-Hot Black

White-Neutral White

Match each color wire from the floodlight camera to the same color from the junction box (green to green, white to white, black to black).
Mount the base with the provided long bracket screw through the center screw-hole.
Ensure the gasket and base is tighten and does not move.
Mount the Floodlight Camera to the base plate.
Adjust the camera position and ersure the top screw-hole matches the one on the base. Mount the camera to the base with the mounting base screw in the top base. Fix the bottom button first and mount the top screw later.
Adjust the position of the LED lights and camera. The installstion is complete.

LED Indicator

Solid Red Initializing

Flashing Blue Ready for Wi-Fi Configuration

Solid Blue Network Connected
Turn on power to your floodlight camera's circuit.

Floodlight Camera Setup

Create a user account

Connect your mobile phone to Wi-Fi.
Download and install the app.
Launch the app and register for a user account following the start-up wizard.

Add a floodlight camera to APP

Log in the app.
From the app Home screen, tap "+" on the upper-right hand corner to go to the scan QR code interface.
Scan the QR Code on the the Floodlight Camera.
Follow the app wizard to finish Wi-Fi configuration.
If you want to change your floodlight camera's Wi-Fi, press and hold the reset button for 5s and repeat this part.
- The floodlight camera works with 2.4GHz Wi-Fi signals. If you have a dual-band router with separate 2.4GHz and 5GHz networks, make sure your phone is connected to the 2.4GHz one.
- If your Wi-Fi network signal is less than 50% where you want to install the floodlight camera, a Wi-Fi signal extender is recommended to boost the signal at the installation point.

Install Memory Card (Optional)

Remove the door on the side of the camera.
Remove the silicone plug.
Insert a microSD card into the slot until a click.
Put the silicone plug back and make sure it is fully plugged in the SD card slot.
Place the door cover back on.

microSD Card	Recommended compatibility: Class 10, Max.128GB. Initialize the card in the app before using it.
Reset Button	Hold for 5 seconds to restart and reset all parameters to default.

Initialize Memory Card

In the app, check the memory card status by tapping on the Storage Status in the Device Settings interface.
If the memory card status displays as Uninitialized, tap to initialize it. The status will then change to Normal.