Removing The Riser 1 Blank - Dell Precision Rack 7910 Owner's Manual

Hide thumbs Also See for Precision Rack 7910:

Owner's manual (142 pages)

Quick start manual (2 pages)

Setup manual (3 pages)

Table Of Contents

100

101

102

103

104

105

106

107

108

109

110

111

112

113

114

115

116

117

118

119

120

121

Table of Contents

3. Remove the expansion-card riser. Pull straight up on the riser using the blue touch points on the top of the riser

CAUTION:

Many repairs may only be done by a certified service technician. You should only perform

troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or

telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by

your warranty. Read and follow the safety instructions that came with the product.

NOTE:

The expansion-card riser 1 can be used only when both the processors are installed.

Steps

1. Unpack the expansion card and prepare it for installation.

For instructions, see the documentation accompanying the card.

2. Press tab A and rotate the latch clockwise.

3. Press tab B and rotate the latch down.

4. Holding the card by its edges, position the card so that the card-edge connector aligns with the expansion-card connector.

5. Insert the card-edge connector firmly into the expansion-card connector until the card is fully seated.

6. Close the latches of tab A and tab B.

Next steps

1. Install the expansion-card riser.

2. If applicable, connect any cables to the expansion card.

3. Follow the procedure listed in

4. Install any device drivers required for the card as described in the documentation for the card.

To see a video on how to remove & install a PCI card and riser, scan this QR code, or click here:

Workstation/R7910/PCI