Attach Power And Scsi Cables; Figure 10 Attaching The Power Cable - Quantum DAT 160 User Manual

Figure 10 Attaching the Power
Cable

Attach Power and SCSI Cables

Quantum DAT 160 User's Guide
USB cable to server's
external USB Port
Power cable
Server's power supply
USB cable to server's
external USB Port
To support the high performance of the tape drive it is important that you
connect to a recommended SCSI bus and use a suitably-rated SCSI cable.
1 Check your server or HBA documentation to ensure that the SCSI bus
and cabling supports up to Ultra160 bus speeds.
2 Attach a spare power cable from the server's internal power supply to
the power connector (see
3 Attach a spare connector on the server's built-in SCSI bus or HBA's
SCSI ribbon cable to the SCSI connector of the drive, (see
Chapter 2 Installing Internal Tape Drives
Attach Power and SCSI Cables
Power cable
figure 11).
Tape drive
figure 11).
18