Table of Contents
Advertisement
Push the door panel downwards, lift it slightly and hook it in
2.
at the top. (Fig. B).
$
Make sure that the door panel is sitting flush with the control
panel.
Malfunction table
Malfunctions often have simple explanations. Please refer to the
malfunction table before calling the after-sales service.
If a meal does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
Malfunction table
Problem
The appliance does not work.
"Set clock" appears in the status
bar. The time displayed is not the
current time. "Select language"
appears in the settings area on the
right.
The oven does not heat up.
"Demo" is displayed in the status
bar.
"Automatic switch-off" appears in
the status bar.
The microwave does not switch
on.
The appliance does not heat up to
the temperature which has been
set.
18
%
Possible cause
Defective fuse
Plug not plugged in
Power cut
Power cut
The oven is in demo mode
Automatic switch-off has been activated. The
oven switches off.
Door not fully closed.
The microwave was not started.
The
button was not pressed.
†
Fully open the door, while holding the panels firmly with one
3.
hand. (Fig. C).
Push the door downwards again and tighten the screws
4.
hand-tight using a flat-bladed screwdriver (blade width 8-
11 mm), close the door. (Fig. D).
&
Caution!
You must not use the oven again until the panels have been
properly refitted.
ã=
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Remedy/information
Look in the fuse box and check that the circuit
breaker is in working order.
Plug it in.
Check whether the kitchen light works.
Turn the rotary selector to set the correct time
then press the
remains unchanged following a power cut.
Switch off the circuit breaker in the fuse box
and then switch back on after approx.
20 seconds. Within the next 2 minutes, press
and hold the
"Demo" disappears from the status bar.
Press any button. The text disappears. You
can make settings again.
Check whether food remains or foreign mate-
rial is trapped in the door. Make sure that the
sealing surfaces are clean. Check whether the
door seal is twisted.
Press the
Press the
'
button. The language set
0
button for four seconds until
@
button.
†
button.
†
Advertisement
Table of Contents
