Table of Contents
Advertisement
Notes
Never treat the self-cleaning surfaces with oven cleaner. If
■
oven cleaner accidentally gets onto the back wall or ceiling,
remove it immediately with a sponge and plenty of water.
Never use abrasive cleaning agents. You will scratch or
■
destroy the highly porous coating.
Never treat the self-cleaning surfaces with a scouring pad.
■
Light discolouration of the enamel does not affect self-
■
cleaning.
Cleaning the cooking compartment floor and side walls
Use a dish cloth and hot soapy water or a vinegar solution.
If there are heavy deposits of dirt, use a stainless steel scouring
pad or oven cleaner. Only use in a cold oven.
Cleaning the glass cover
The glass cover can be removed from the oven ceiling for
cleaning.
ã=
Risk of burns!
Do not remove the panels immediately after switching the
appliance off. The oven must be cold.
Removal
Place a tea towel in the oven.
1.
Pull the clip on the oven ceiling forwards. (Fig. A)
2.
Press the front of the glass cover down using the thumb of
your other hand. Let go of the clip.
Slide the cover forwards using both hands and rest it on the
3.
grill element. (Fig. B)
$
Slide it slightly backwards again. (Fig. C)
4.
Tilt down at the side and remove. (Fig. D)
5.
&
ã=
Risk of injury!
Never touch or clean the microwave antenna (A)!
For light soiling:
Wash the glass cover using hot soapy water.
For heavy soiling:
Clean the glass cover in the same way as the enamel surfaces
in the oven.
Refitting
Slide in the cover with the smooth side facing downwards
1.
and rest it on the grill element. (Fig. A)
%
'
$
Use both hands to slide it back into the two catches. (Fig. B).
2.
$
Pull the clip forwards and push the glass cover upwards. Let
3.
go of the clip. (Fig. C)
&
Remove the tea towel from the oven.
ã=
Risk of serious damage to health.!
Never operate the appliance without the microwave glass
cover. Microwave energy may escape.
Cleaning the glass panels
The glass panels can be removed from the oven door for
cleaning.
ã=
Risk of burns!
Do not remove the panels immediately after switching the
appliance off. The oven must be cold.
Removal
Open the oven door.
1.
Undo the two screws on the door using a flat-bladed
2.
screwdriver (blade width 8-11 mm). Hold the door panel
firmly while doing this. (Fig. A).
Position the door at an angle and pull out the panel upwards
3.
by the door handle. (Fig. B).
$
Close the door.
4.
Notes
Clean the glass panel with glass cleaner and a soft cloth.
■
Do not use any sharp or abrasive agents. The glass scraper
■
is not suitable.
Refitting
Insert the door panel into the guide with both hands. (Fig. A).
1.
%
%
17
Advertisement
Table of Contents
