Summary of Contents for Backyard Discovery LITTLE BRUTUS 2051171B
Page 1
LITTLE BRUTUS SWINGSET MANUFACTURED BY: Backyard Discovery 3305 Airport Drive Pittsburg, KS 66762 Model # 2051171B 800-856-4445 Owner's Manual & Assembly Instructions average 2 person assembly time assembly time may vary based on skill level For the most up to date assembly manual, to register your set, or to order replacement parts please visit www.backyarddiscovery.com...
Page 2
INSTALLATION SERVICES AVAILABLE! Need a helping hand? Let our team of professionals handle the installation for you! *Installation services are only available to U.S. customers. With Go Configure, we bring you 18 years of experience right to your doorstep. We service a wide array of indoor and outdoor recreation products that most consumers don’t have the time or ability to deliver &...
Page 3
Owner’s Manual Please Read This Before Starting Assembly MISSING A PART? CALL US BEFORE GOING BACK TO THE STORE Th e store where you made your purchase does not stock parts for this item. If you have assembly questions or you are missing or have damaged parts, please call 1-800-856-4445 you can also visit www.backyarddiscovery.com...
Botanical, Adventure Playsets, and Leisure Time Products. Backyard Discovery warrants that this product is free from defect in materials and workmanship for a period of one (1) year from the original date of purchase. Th is one (1) year warranty covers all parts including wood, hardware, and accessories. All wood carries a fi ve (5) year pro-rated warranty against rot and decay. Refer to the schedule below for charges associated with replacement of parts under this Limited Warranty.
Page 5
Owner’s Manual Operating Instructions and Safety Warnings WARNING: BURN HAZARD • Pay special attention to plastic and metal surfaces as they may be hot enough to cause burns. • Always check the temperature of the product before NOTE: letting your children play on it. •...
Page 6
Owner’s Manual Please Read This Before Starting Assembly Positioning Your Playcenter Suggested Playground Surfacing • Th e playcenter is designed to be installed on a level • Do not install home playground equipment over surface by an adult with an adult helper. Place concrete, asphalt, packed earth, grass, carpet, or any in a fl at area of your yard to minimize ground other hard surface.
Page 7
Owner’s Manual Please Read This Before Starting Assembly APPENDIX A The following information is from the United States X3.1.3.2 Do not install loose-fi ll surfacing over hard surfaces such as concrete or asphalt. Consumer Product Safety Commission’s Information X3.1.4 Poured-In-Place Surfaces or Pre-Manufactured Sheet for playground surfacing material;...
Page 8
• Check all moving parts including swing seats, Backyard Discovery assumes no responsibility or ropes, cables, and chains for wear, rust, or other liability for any charge incurred by the Customer for deterioration.
Page 9
Owner’s Manual Assembly Tips Protrusion Hazard Incorrect Correct If you see exposed threads and your bolt protrudes beyond the T-Nut you may have over tightened the bolt or used incorrect hardware. If you’ve overtightened, remove the bolt and add washers to eliminate the protrusion.
Owner’s Manual Assembly Tips ASSEMBLY TIP: Keep an eye out for these boxes which will contain helpful pictures and information making the assembly process as quick and painless as possible. Sorting Hardware NUT BARREL SCREW T-NUT WASHER FLAT BOLT HEX BOLT SCREW PWH H100545...
Page 11
Owner's Manual Tools Required for Installation...
Page 12
Owner's Manual Basic Setup Dimensions & Assembly Notes Place the set on level ground, not less than 6'-7" [2 m] from any structure or obstruction such as a fence, garage, house, overhanging branches, laundry lines, or electrical wires. • While assembling unit, take time before and after each phase to make sure fort is level. If fort is not level, assembly will be difficult and improper assembly may result.
Page 14
Accessories (Not to Scale) Parts Identification A4M01013 BOTTOM LEG (x4) A4M01015 TOP LEG (x4) A4M01294 SWING BEAM END (x2) A4M01293 CENTER SWING BEAM (x1) A4M01019 A4M01020 METAL BRACKET GREY A4M01024 LEG CONNECTING TUBE (x8) METAL BRACKET GREEN (x4) (x4) A4M01022 TOP BEAM CONNECTING TUBE (x2) A4M01018...
Page 15
Accessories (Not to Scale) Parts Identification A6P00435 A6P00375 A6P00366 BYD TAG STICKER (SMALL) WARNING LABEL STICKER SWING SET FOOT (x1) (x4) (x1) A4M01040 DUCTILE HANGER WITH INSERT WZ (x6) H100242 QUICK LINK (LONG) WZ (x10) A4M01136 CHAIN GREEN 48.25" (x4) A6P00362 26"...
Page 16
STEP 1 H100591 BOLT CARRIAGE WZ (x4) 5/16x2 1/2 A4M01020 LEG CONNECTING TUBE (x4) A4M01013 BOTTOM LEG (x4) H100811 BOLT CARRIAGE WZ (x4) 5/16x2 3/4 A4M01015 TOP LEG (x4) A4M01019 H100499 NUT BARREL WH WZ METAL BRACKET GREY (x8) (x8) 5/16x7/8 NOTE: REPEAT THIS STEP 4 TIMES.
Page 17
STEP 2 H100811 BOLT CARRIAGE WZ (x4) 5/16x2 3/4 A4M01294 A4M01293 SWING BEAM END CENTER SWING BEAM (x2) (x1) A4M01022 H100818 BOLT HEX M12x50mm WZ A4M01024 TOP BEAM CONNECTING TUBE (x2) METAL BRACKET GREEN (x6) M12x 50mm (x4) H100242 QUICK LINK (LONG) WZ (x6) H100819 LOCK NUT WZ...
Page 20
SETUP WEB SWING WEB SWING SETUP INSTRUCTIONS: FOLLOW INSTRUCTIONS BELOW BEFORE USING THE WEB SWING. H100831 NUT BARREL PTH BLK H100832 BOLT PTH BLK (with LOCTITE) 1/4x3/4 1/4x3/4 IMPORTANT: SLIDE ROPE LOOPS OVER TUBE ENDS FIRST! SLIDE NARROW END OF TUBES INTO LARGER OPENING AFTER SLIDING (x4) ROPE LOOPS ONTO TUBES.
Page 21
STEP 5 A4M01136 CHAIN GREEN 48.25" (x4) H100242 A6P00362 QUICK LINK (LONG) WZ 26" HD BELT SWING (x4) A4M01126 (x2) 26" WEB SWING (x1) TIGHTEN QUICK LINK INSERT CHAIN INTO QUICK LINK (x1) 26" WEB SWING (x4) CHAIN GREEN 48.25" (x4) QUICK LINK (LONG) WZ (x2)