Mitsubishi Electric MR-J5W-G User Manual page 13

Network connection procedure
Follow the procedures below to set up the network.
1.
Connect the master station and the servo amplifier with a network cable. There is no difference between CN1A and
CN1B.
2.
Turn on the power of the master station and the servo amplifier.
3.
Open the diagnostic screen of GX Works3 and make sure that there is no error in the network. If the network is not
connected, check the following contents.
• Check if an alarm has occurred in the servo amplifier. If an alarm occurs, refer to the following manual and cancel the
alarm.
MR-J5 User's Manual (Troubleshooting)
• Check the rotary switch. Make sure that the 4th octet of the IP address set by the master station matches the setting of the
rotary switches.
Network disconnection procedure
Refer to the following.
 Page 8 Disconnecting the communication
Changing the network configuration
Refer to the following.
 Page 8 Changing the communication configuration
1
1 CC-Link IE TSN
11
1.2 Startup