Table of Contents
Advertisement
Venting Introduction
This wood stove operates on a
natural draft system, in which the chimney
system pulls air through the stove. This unit
must be installed in accordance with the
following detailed descriptions of venting
techniques; not installing the stove in
accordance with the details listed here can
result in poor stove performance, property
damage, bodily injury or death. Avoid
make‐shift compromises when installing the
venting system. Englander is not
responsible for any damage incurred
due to a poor or unsafe installation.
Be certain that all aspects of the
venting system are installed to the venting
manufacturer's instructions, particularly the
required clearances to combustibles. Also,
be certain to use an attic radiation shield to
prevent insulation from contacting a
chimney which passes through an attic.
The chimney system is the "engine"
which drives a wood stove, so it is
imperative for proper unit function that the
venting system be installed exactly as
described in the following section.
If questions arise pertaining to the
safe installation of the stove, our Technical
Support line (877‐356‐6663) is available.
Contact your local code official to be certain
your installation meets local and national
fire codes, and if you're uncertain about
how to safely install the stove, we strongly
recommend contacting a local NFI certified
installer to perform the installation.
WARNING: Venting system surfaces get HOT, and can cause burns if
touched. Noncombustible shielding or guards may be required.
INSTALLATION
Venting Guidelines
• ALWAYS install vent pipe in strict
• DO NOT CONNECT THIS WOOD
• DO NOT install a flue pipe damper
• USE an approved wall thimble when
• INSTALL three sheet metal screws at
• AVOID excessive horizontal runs and
• INSPECT your venting system often,
• CLEAN the venting system as
• ADHERE to the 10‐3‐2 rule regarding
• INSTALL single wall chimney
adherence to the instructions and
clearances included with your
venting system.
STOVE TO A CHIMNEY FLUE WHICH
ALSO SERVES ANOTHER APPLIANCE.
or any other restrictive device in the
exhaust venting system of this unit.
passing through a wall and a ceiling
support/fire stop when passing
through a ceiling.
every chimney connector joint.
elbows, as both will reduce the draft
of the venting system and will result
in poor stove performance.
to be certain it is clear of creosote,
fly‐ash and other restrictions.
detailed in the maintenance section
of this manual.
chimney terminations.
connector with the male end down
to prevent creosote leakage. Follow
double wall chimney connector
manufacturer's instructions
regarding proper pipe installation.
Advertisement
Table of Contents
