Door Hinges - England's Stove Works 15-W01 Installation & Operation Manual

Burner tube replacement
There are three different burner tubes in the top of the stove. To replace a tube, first
be sure that you order the correct tube you need to replace. Then using a 5/16" socket or
open end wrench, remove the screw located on the left side of the tube. Be sure to keep the
screw. Push the tube to the right then remove the tube (pulling the tube back to the left
after that side has been removed from the hole). To replace, reverse the above
procedure...make sure to install the tubes in the correct order. (Front to Back)
Ceramic fiberboard replacement
To replace a cracked or broken board, first
remove the front burner tube. Then remove the
board you need to replace. Install the new board
(the two boards should sit flush on the tubes side
by side). Replace the tube previously removed.

Door hinges

The hinges on this unit were designed to be adjustable. The plates are secured using a
½" bolt and nut. To adjust the hinge plates in or out first remove the door, then use a ½" socket
and ½" open ended wrench (one on the nut and one on the bolt head) and loosen the bolt/nut.
Slide the plate in/out as desired and then use the socket and wrench to tighten the bolt/nut. *
Use care when adjusting hinges. If enough room is not left for the door to clear the side of the
unit, the hinge could break. *
Heat shield and back panel removal (to access other components)
There are two 5/16" screws that are on the rear of the heat shield. To remove the heat
shield, using a 5/16" socket or open ended wrench, remove the two screws. Then pull the heat
shield up and back off the back panel. Next to remove the back panel, there are three 5/16"
screws on the rear of the panel. Using a 5/16" socket or open ended wrench, remove the three
screws. It may be necessary to pry the top of the panel with a flat head screwdriver (at the top
of the stove). Lift the panel up and off the stove.
REPLACING COMPONENTS