Daikin R32 Sky-Air RZAG-M Service Manual page 94

ESIE17-08 | Part 3. Repair
16. Loosen and remove the 2 screws (10) that fix the wiring.
17. Loosen and remove the screw (11) that fix the wiring.
18. Loosen and remove the 3 screws (12) that fix the wiring.
19. Disconnect the 3 connectors (13) from the terminal block.
20. Loosen and remove the 2 screws (14) that fix the terminal block.
Finally, strip the Main PCB assembly (rear)
21. Loosen and remove the 2 screws (1) that fix the wiring.
22. Cut the 2 tie wraps (2) that fix the wiring.
23. Unlock the 9 standoffs (3) that fix the electrical noise filter PCB.
24. Remove the wiring from the cable clamp (4).
25. Remove the electrical noise filter PCB (5).
3
2
5
3
1. Screw
2. Tie wrap
3. Standoff
Installation
1. Proceed in reverse order.
Page 94
R32 Sky-Air RZAG-M
Figure 3-27: Stripping the main PCB assembly 1-phase (rear)
3.3. Unit specific repair procedures
4. Cable clamp
5. Electrical noise filter PCB
2
3
4
1
15/11/18 | Version 1.1