Power Requirements; Physical Characteristics - National Instruments NI cRIO-9002 User Manual And Specifications

MTBF
The following MTBF specifications apply to the cRIO-9002/9004.
MTBF

Power Requirements

You must use a National Electric Code (NEC) Class 2 power source with the cRIO-9002/9004.
Recommended power supply
Power consumption
Controller only
Controller supplying power to eight
CompactRIO modules
Power supply
On powerup
After powerup
Note The cRIO-9002/9004 powers up only at 9 V or higher, but when these
devices are powered on, they can run on as little as 6 V.

Physical Characteristics

If you need to clean the module, wipe it with a dry towel.
Tip For two-dimensional drawings and three-dimensional models of the C Series
module and connectors, visit
Screw-terminal wiring
Gauge
Wire strip length
Temperature rating
Torque for screw terminals
Wires per screw terminal
Ferrules
1,253,788 hours at 25 °C; Bellcore Issue 6,
Method 1, Case 3, Parts Count Method
48 W secondary, 18 VDC to 24 VDC
7 W maximum
17 W
9 V to 35 V
6 V to 35 V
ni.com/dimensions
0.5 mm
copper conductor wire
7 mm (0.28 in.) of insulation stripped from the
end
85 °C
0.5 N · m to 0.6 N · m (4.4 lb · in. to
5.3 lb · in.)
One wire per screw terminal
0.25 mm
NI cRIO-9002/9004 User Manual and Specifications | © National Instruments | 13
and search by module number.
2 2
to 2.1 mm (20 AWG to 14 AWG)
2 2
to 1.5 mm